CCNA Guide to Cisco Networking, Fourth Edition Chapter 14 Lab Solutions
Chapter 14 Lab Solutions
The labs in this chapter use the Security Device Manager demo that was installed in Lab
6.6. Make sure the students are using that same computer to do these SDM labs.
Activity Questions Lab 14.1
5. One-step lockdown will immediately deliver a set of pre-defined security
features to the router without your input.
6. Check the running configuration for security; list problems and
recommendations; allow user to choose what to fix; configure the router
Review Questions Lab 14.1
1. What is the purpose of the Security Audit Wizard?
2. What are the two ways the Security Audit Wizard allows you to fix security problems?
3. What is your opinion regarding using the Security Audit Wizard feature of the SDM?
4. List two appropriate situations in which to use the Security Audit Wizard.
Activity Questions Lab 14.2
9. Low security does not track application-specific traffic.
Review Questions Lab 14.2
1. What are the two firewall options presented in the SDM?
2. What are the two differences between the basic and advanced configuration
wizards?
3. How do you determine the untrusted interface?
4. How do you determine the trusted interface?
5. In terms of ease of configuration, how does using the SDM to configure a firewall
compare to configuration using the CLI?
Activity Questions Lab 14.3
18. SHA-1; 3DES
2
20. Failure reason and recommended actions
Review Questions Lab 14.3
1. When would you configure a GRE tunnel?
2. When would you configure a Dynamic Multipoint VPN?
3. What does using WebVPN allow you to do that other VPN configurations do not?
4. What hashing algorithm and encryption algorithm does Cisco use for its site–to-site
VPN implementation?