Problem 11.80
What is the theoretical minimum number of parts for a 3-prong electrical plug.
Problem 11.81
What features of a typical car windshield violate the principles of DFA?
Problem 11.82
Sketch out components of a calculator that would observe the rules of design for assembly.
Inst. Ans. 11.82 Assuming: The key operation is enter numbers and operations and display results.
Problem 11.83
11.83 Why is it preferable to have fewer datums?
Problem 11.84
Which GD&T tolerances can be verified using calipers?
Problem 11.85
What processes are better suited to (a) round, (b) prismatic, and (c) complex parts?
Problem 11.86
Some industries, such as electronics, are based on a smaller set of standardized processes. How is this
possible?