Chapter 9 auxiliary Views test
INSTRUCTIONS
Answer the questions with short, complete statements or draw–
ings as needed.
QUESTIONS
1. Describe the purpose of auxiliary views.
2. When projecting an auxiliary view from the edge view of the
surface, what is the angle of projection in relationship to the
edge view?
3. Discuss how viewing-plane lines can be used to establish an
auxiliary view.
4. When is it necessary to enlarge an auxiliary view?
5. Describe the procedure for drafting an enlarged auxiliary
view.
6. Describe a situation when a secondary auxiliary view is
necessary.
7. Identify the ASME document that governs auxiliary views.
Chapter tests
and problems
8. What method is used to show the alignment between the
auxiliary view and the direct projection from the inclined
surface?
9. If the axis of a hole is perpendicular to an inclined surface,
what is the shape of the hole in an auxiliary view of the in-
clined surface?
10. If the axis of a hole is at 458 to an inclined surface, what is the
shape of the hole in an auxiliary view of the inclined
surface?
11. Explain the difference between a partial auxiliary view and
a full auxiliary view.
12. Why is a partial auxiliary view normally used?
13. Describe the procedure used when it is not possible to align
the auxiliary view directly from the inclined surface.
14. How are multiple removed auxiliary views oriented and
labeled on a drawing?
15. Describe the process of cross-reference zoning.
59728_ch09_EOC_ptg01.indd 1 03/02/16 10:25 am
Chapter 9
Auxiliary Views
Answers to End-of-Chapter Test Questions
37